For universal grinding work from coarse to fine grinding..Coated Belt,Al/Oxd,3/4"x18",36 Grit, Coated, 3/4" W, 18" L, 36 Grit, Aluminum Oxide Abrasive belts from PFERD are designated as 'abrasive belts' in ISO 2976.
016 CS Wire, 5/8-11 Thread The loosely-twisted knots cover a larger surface area and are ideal for heavy-duty cleaning and surface conditioning on uneven surfaces.
.Bearing Insert Spherical Set Screw Collar Bearing 1" Id,150825 Bearings are precision ground and suitable for high speed applications (such as fans) and for use under rugged conditions (such as farm machinery).
GN 319.5 both the threaded stud and tapped spindle type revolving ball knobs can be utilized instead of revolving handles e., with handwheels or crank handles..
They work according to the toggle principle: lever and clamping bar move in the opposite direction. GN820.4 horizontal acting toggle clamps have a safety function whereby, during closing, a spring loaded safety hook latch ensures a secure locking connection.
Socket set screws with safety twist ball (types V and VR) are designed so the flat faced ball cannot twist more than a maximum of 9 degrees. GN605-M12-16-BN Socket Set Screw This allows full clamping of the flat faced ball at all times.GN 605 socket set screws with full ball point (type A) are used in applications where a ball point contact is required.
The design with GPC thread coating provides a higher degree of safety.DIN906-NI-M10X1-A Threaded Plugs, Tapered Thread The tightness depends on the medium, pressure, temperature and material pairing..
.1 vertical acting toggle clamps work according to the toggle principle: lever and clamping bar move in the same direction. A spindle assembly with neoprene rubber tip is also included for Type BC.
JW Winco GN 516-VK8-58 Cam Latch This cam latch housing is designed for common applications such as making a tight and vibration-proof interlock in the end position (clamping position) in connection with an elastic sealing.
.JW Winco GN 516-VDE-63 Cam Latch This cam latch housing is designed for common applications such as making a tight and vibration-proof interlock in the end position (clamping position) in connection with an elastic sealing.
2 semi-split shaft collars are typically used as an end stop, and can easily be assembled with a high clamping force via the clamping screw without causing damage to the surface of the shaft or axle.GN 706.
GN310-8-63-A-NI Gear Lever Stainless Steel Used for actuating the material flow through hydraulic valves via the lever handle or, used as control levers for on / off, start / stop applications where the lever handle is attached to set collars, split hubs, or eccentric cams, are example uses of these standard parts..
JW Winco GN 516-SCH-49 Cam Latch This cam latch housing is designed for common applications such as making a tight and vibration-proof interlock in the end position (clamping position) in connection with an elastic sealing.
Together with a dimpled hole or a groove on the shaft diameter, the shaft collars can be positioned exactly and, at the same time, damage to the clamping point can be avoided.GN705-26-E-NI Set Collar Stainless The clamping is done radially on the shaft or axle surface..
GN 42 leveling feet are simple, economically priced components and can be used universally thanks to the wide range of possible combinations of the base and the stud / socket versions..
GN598.3-KU-23 Retractable Handle Plastic A positive lock is achieved in the operating position by way of a tapered seat located in the hub of the mechanism.. A compression spring locks the handle in both end positions.