Spiral Point Tap, 1/4-28, Plug, UNF, 3 Flutes, TiAlN

Jobber Length Drill Bit, Drill Bit Size 5/16 in, Drill Bit Point Angle 118 Degrees , High Speed Steel, Bright (Uncoated), Decimal Equivalent 0.3125, Fractional Inch, Drill Bit Point Type Split Point, Non-Coolant Through, Number of Coolant Holes 0.

Jobber Length Drill Bit, Drill Bit Size 15/32 in, Drill Bit Point Angle 135 Degrees , High Speed Steel, Black Oxide, Decimal Equivalent 0.4688, Fractional Inch, Drill Bit Point Type Split Point, Non-Coolant Through, Number of Coolant Holes 0.

1130, Wire, Drill Bit Point Type Split Point, Non-Coolant Through, Number of Coolant Holes 0.Hs Jobber Drill 118-Deg Sp Tin-Tip 33 1, Drill Bit Size #33, Drill Bit Point Angle 135 Degrees , High Speed Steel, TiN Tipped, Decimal Equivalent 0.

Jobber Length Drill Bit, Drill Bit Size J, Drill Bit Point Angle 135 Degrees , High Speed Steel, Black Oxide, Decimal Equivalent 0.2770, Letter, Drill Bit Point Type Split Point, Non-Coolant Through, Number of Coolant Holes 0.

Taper Shank Drill Bit, Drill Bit Size 37/64 in, Drill Bit Point Angle 118 Degrees , Conventional Point, High Speed Steel, Black Oxide.

1100, Wire, Drill Bit Point Type Split Point, Non-Coolant Through, Number of Coolant Holes 0.

-28, UNF, Overall Length 3 1/8 in, HSS-E, TiAlN, Right Hand, Thread Length 1 1/4 in, 75 Percent Thread Drill Size 5.45 mm, Thread Limit 2B, Class of Fit 2B, Number of Flutes 3.Spiral Point Tap, Thread Size 1/4 In.

2-Flute Carbide Square Single-End HP End Mill for Alum CTD CEM-AM2 Bright 1/8x1/8x3/8x1-1/2 1/8 in, Neck Dia. Not Applicable.

Spiral Point Tap, Thread Size 1/4 In.

2-Flute Carbide Square Single-End HP End Mill for Alum CTD CEM-AM2 Bright 1/8x1/8x3/8x1-1/2 1/8 in, Neck Dia.