58 Dia X 58 Shank 60Deg Carbide Drill Mill Blue Series

Mill Diameter Inch 316 Number of Flutes 2 Material Cobalt Length of Cut Inch 12 Shank Diameter Inch 316 FinishCoating Bright Single or Double End Double Center Cutting Yes Overall Length Inch 214 Flute Direction Right Cutting Direction Right Variable Helix No Helix Angle 30 Excellent tool geometry for slotting, keying and general purpose milling, plus the added economy offered by the doubleend design.

Connection Type Shank American Standard Number ANSI 406 Cutting Diameter Inch 34 Cutting Width Inch 18 Tooth Configuration Straight Material High Speed Steel Shank Diameter Inch 12 12 shank diameter.

Shank Type Taper Shank Taper Size BT40 Pilot Diameter Inch 12 Projection Flange to Nose End Decimal Inch 175 Nose Diameter Decimal Inch 138 DIN Coolant option standard All Ground Body.

Drill Bit Size Wire 19 Drill Point Angle Degrees 118 Drill Bit Material Carbide Tipped Drill Bit FinishCoating Bright Flute Type Spiral Cutting Direction Right Shank Type Straight Coolant Through No Designed for drilling abrasive and nonferrous materials such as castings, hard rubber, and copper alloys They are NOT recommended for drilling steel or other ferrous materials Jobber length 118Deg point High Speed Steel bodies.

.Multi Flute Typhoon end mill design allow them to be run at higher RPM than conventional end mills as well as increase tool life without chipping.

9/32" Diameter x 5/16" Shank 4-Flute Regular Length Typhoon Red Series Carbide End Mills The unique geometry of the Typhoon end mill combined with its modified AlTiN coating make it an excellent choice for demanding applications.

Type Positive Drive Tap Adapter Shank Diameter Decimal Inch 122 Fully compatible with Bilz System.

Material Solid Carbide Mill Diameter Inch 58 Shank Diameter Inch 58 Length of Cut Inch 114 Point Angle 60 Number of Flutes 2 FinishCoating Bright DrillMills can be used for drilling, slotting, and profile milling 2 Flute 60Deg 90Deg included point angle Made from submicron grain carbide Cutting diameter tolerance 00000002.

Type Positive Drive Tap Adapter Shank Diameter Decimal Inch 122 Fully compatible with Bilz System.

Material Solid Carbide Mill Diameter Inch 58 Shank Diameter Inch 58 Length of Cut Inch 114 Point Angle 60 Number of Flutes 2 FinishCoating Bright DrillMills can be used for drilling, slotting, and profile milling 2 Flute 60Deg 90Deg included point angle Made from submicron grain carbide Cutting diameter tolerance 00000002.