Guyana Stick Flag 8x12

Shank Type Taper Shank Taper Size CAT50 Hole Diameter Inch 12 Nose Diameter Decimal Inch 138 Projection Decimal Inch 263 Through Coolant Yes DIN Coolant option standard All Ground Body Premium balanced to 25,000 rpm Comes with certificate.

Shank Type Taper Shank Taper Size HSK63A Hole Diameter mm 4 Projection mm 80 Nose Diameter mm 15 Through Coolant Yes Unsurpassed Accuracy Concentricity of Less than or equal too00001 3 Micron with tool shrunk in holder Coolant Ports Each holder has 4 coolant ports in the nose to ensure coolant gets right to the tool Max Gripping Torque Tool is gripped 360Deg along the entire length of bore producing very high gripping torque, preventing chatter Increased Production Decrease down time the total time elapsed to remove one cutting tool and insert another is less than 10 seconds Balanced GS follows the strictest balance standards Our holders are prebalanced G25 up to 30,000rpm Extended Holder Life With double tempered tool steel construction, reduced centrifugal forces, minimized bore contamination, and minimized chatter, a GS Shrink Fit Toolholder should far outlast a standard end mill holder Chip load distributed evenly along cutting edge of tool which results in longer tool life Short projections are possible because no mechanical clamping devices are used This results in greater rigidity and resistance to bending Since Shrink Fit toolholders have no moving parts they offer the greatest repeatability of any tool holding system on the market.

FAIRCHILD INDUSTRIES FCH1034 Flex Radiator Hose, Single ID Hose, ID1 175, ID2.

Push-In L-Fitting QSLV-1/8-8 Size=Standard, Nominal Size=5,5 Mm, Type Of Seal On Screw-In Stud=Coating, Assembly Position=Any, Container Size=10.

Push-In L-Fitting QSLV-1/8-8 Size=Standard, Nominal Size=5,5 Mm, Type Of Seal On Screw-In Stud=Coating, Assembly Position=Any, Container Size=10.