Socket Head Cap Screw Allen Dr 1/2in-13 X 1in Grade 18-8 Stainless Steel 5PK

.3/4 TON Component Stabilizing Stand - Single Post The heavy-duty materials and precise adjustment allow the operator to work with speed and ease.

Safety Glasses, Gray, Orange temples.

SPEAKMAN RPG41-0108 Repair Part Mark II Shower Index.

3.Machine Screw, Round Head, Phil/Sltd Comb Drive #8-32 X 1-1/2in Solid Brass 25PK They are frequently used in machinery and appliances.

The sides of the lag shield push out against the inside of the hole once the lag screw is installed, thereby locking it in place.Lag shield anchors allow lag screws to be installed into concrete and masonry walls. After drilling a hole into the material, lag shields should be tapped into place ribbed side first until flush with the surface. Long Lag Shield, 5/16" Dia, 1-3/4" L, Alloy Steel Plain, 50 PK Size: 5/16 inch X 1-3/4 inchAllows for lag screw bolts to be installed into concrete, brick & blockInserts into a hole by tapping with a hammer until flushLag screw expands the lag shield against the walls of the holeDrill hole with masonry drill bit based on diameter on anchor.

Thick Stainless Steel Door Edge Reinforcer Used to reinforce door edgesHelps prevent a forced entryMounts to door edge 1-3/4 in. Assists in preventing a forced entry.Stainless steel constructionAccommodates lockset or deadboltMounting hardware includedA Phillips head screwdriver is required for installationFor further dimensional information, please see the line drawing.

6. Size: #12-24 X 5/8 inchRound Head, Phillips/Slotted Combination DriveUse with nuts or pre-threaded holes of the same diameter & thread sizeOften used in machinery & appliancesNuts and washers not includedThread Type: Coarse, Thread Class: UNC-2A, Point Style: BluntSpecification(s) Met: ASME B18.1.3 & ASME B1.

Socket Head Cap Screw Allen Dr 1/2in-13 X 1in Grade 18-8 Stainless Steel 5PK Length is measured from underneath the head to the base of the cup point..

1.6.

Use an Allen wrench (hex key) to secure with required torque as needed.Size: 1/2 inch-13 X 1 inchHex (Allen) DriveInstalls using an Allen wrenchCan be used in tight spaces where there may not be room for a socket tool or wrenchOften used in machinery, tools & diesThread Type: Coarse, Thread Class: UNC-3A, Point Style: BluntSpecification(s) Met: ASME B18.Socket Head Cap Screw Allen Dr 1/2in-13 X 1in Grade 18-8 Stainless Steel 5PK Length is measured from underneath the head to the base of the cup point..