110mm Dia X 38 Shank 2Flute Regular Length HSCO Cobalt End Mill

It can be widely used for boring, milling, drilling and tapping as well as for grinding operation, and is available for all sizes.9/32" ER11 Collets - ER11 collets collapse approximately 1/64" with full accuracy This collet can clamp for a specific standard size and its next size..

Tool Post Holder Number S Tool Post Holder Type Boring Bar Holder Lathe Swing Inch 613 Overall Length mm 80.

Drill Bit Size Inch 58 Drill Bit Material High Speed Steel Drill Point Angle Degrees 118 Drill Bit FinishCoating Black Oxide Overall Length Inch 18 Through Coolant No 118Deg point.

Drill Bit Size Inch 1332 Shank Taper Designation MT4 Drill Point Angle Degrees 118 Drill Bit Material High Speed Steel Drill Bit FinishCoating Black Oxide Overall Length Inch 20 Through Coolant No.

Drill Blank Size Inch 732 Drill Blank Size Decimal Inch 02188 Blank Length Inch 334 Made from hardened HRC 6365 high speed steel and ground, can be used as punches, gauges, pins or ground for special tools High Speed Steel 00000 00003.

Cutter Diameter Inch 312 Cutting Width Inch 2564 Tooth Configuration Plain Material High Speed Steel FinishCoating Uncoated Arbor Hole Diameter Inch 1 Number of Teeth 20.

Type ER Collet Series ER20 Hand or Pipe Tap Hand Through Coolant No Tap Size Metric M8 For synchronous, rigid tapping operations using ER collet chuck Collet bore is exact tool diameter with square drive for accuracy and rigidity.

Mill Diameter mm 11 Number of Flutes 2 Material Cobalt Length of Cut Inch 1316 Shank Diameter Inch 38 FinishCoating Bright Single or Double End Single Center Cutting Yes Overall Length Inch 212 Flute Direction Right Cutting Direction Right Variable Helix No Helix Angle 30 These end mills are furnished as regular with righthand cutting and righthand helical flutes All shanks are flatted for holder set screw Designed for slotting, drilling, pocketing and generalpurpose operation 2 helical flutes Single end with weldon shank Centre cutting Keyway tolerance.

Type ER Collet Series ER20 Hand or Pipe Tap Hand Through Coolant No Tap Size Metric M8 For synchronous, rigid tapping operations using ER collet chuck Collet bore is exact tool diameter with square drive for accuracy and rigidity.

Mill Diameter mm 11 Number of Flutes 2 Material Cobalt Length of Cut Inch 1316 Shank Diameter Inch 38 FinishCoating Bright Single or Double End Single Center Cutting Yes Overall Length Inch 212 Flute Direction Right Cutting Direction Right Variable Helix No Helix Angle 30 These end mills are furnished as regular with righthand cutting and righthand helical flutes All shanks are flatted for holder set screw Designed for slotting, drilling, pocketing and generalpurpose operation 2 helical flutes Single end with weldon shank Centre cutting Keyway tolerance.