1/4 Diameter X 1/4 Shank 2-Flute Long Length Ball Nose Blue Series Carbide End Mills

Shank Type Taper Shank Taper Size HSK63A Hole Diameter Inch 34 Projection Decimal Inch 394 Nose Diameter Decimal Inch 13 Through Coolant Yes Unsurpassed Accuracy Concentricity of Less than or equal too00001 3 Micron with tool shrunk in holder Coolant Ports Each holder has 4 coolant ports in the nose to ensure coolant gets right to the tool Max Gripping Torque Tool is gripped 360Deg along the entire length of bore producing very high gripping torque, preventing chatter Increased Production Decrease down time the total time elapsed to remove one cutting tool and insert another is less than 10 seconds Balanced GS follows the strictest balance standards Our holders are prebalanced G25 up to 30,000rpm Extended Holder Life With double tempered tool steel construction, reduced centrifugal forces, minimized bore contamination, and minimized chatter, a GS Shrink Fit Toolholder should far outlast a standard end mill holder Chip load distributed evenly along cutting edge of tool which results in longer tool life Short projections are possible because no mechanical clamping devices are used This results in greater rigidity and resistance to bending Since Shrink Fit toolholders have no moving parts they offer the greatest repeatability of any tool holding system on the market.

Insert Style: TPU Insert Size: 434 Material: Carbide Manufacturer's Grade: PTM30U Material Grade: C5, C5-C6.

On: Variety of Steels, Cast Iron, Non-Ferrous metals, Plastics, Abrasive type materials..

Collet System ER Collet Series ER16 Shank Type Taper Shank Taper Size CAT50 Projection Decimal Inch 412 DIN Coolant option standard All Ground Body Factory Balanced to save spindle life, tool life and increased productivity Threaded through holes for a backup screw tool stop or coolant through when removed Wrench not included Premium balanced to G25 At 30,000 rpm.

Collet System ER Collet Series ER16 Shank Type Taper Shank Taper Size CAT50 Projection Decimal Inch 412 DIN Coolant option standard All Ground Body Factory Balanced to save spindle life, tool life and increased productivity Threaded through holes for a backup screw tool stop or coolant through when removed Wrench not included Premium balanced to G25 At 30,000 rpm.