3/16 Dia X 3/16 Shank 0.020 Radius 2-Flute Corner Radius Typhoon Red Series Carbide End Mills

It can be widely used for boring, milling, drilling and tapping as well as for grinding operation, and is available for all sizes.0-11.5mm (0.4527) Collet This collet can clamp for a specific standard size and its next size.

Material High Speed Steel Blade Diameter Inch 234 Blade Thickness Decimal Inch 0036 Arbor Hole Diameter Inch 34 Connection Type Arbor Number of Teeth 72 High Speed Steel.

Shank Type Taper Shank Taper Size CAT50 Hole Diameter Inch 1 Projection Decimal Inch 394 Nose Diameter Decimal Inch 173 Through Coolant Yes Unsurpassed Accuracy Concentricity of Less than or equal too00001 3 Micron with tool shrunk in holder Coolant Ports Each holder has 4 coolant ports in the nose to ensure coolant gets right to the tool Max Gripping Torque Tool is gripped 360Deg along the entire length of bore producing very high gripping torque, preventing chatter Increased Production Decrease down time the total time elapsed to remove one cutting tool and insert another is less than 10 seconds Balanced GS follows the strictest balance standards Our holders are prebalanced G25 up to 30,000rpm Extended Holder Life With double tempered tool steel construction, reduced centrifugal forces, minimized bore contamination, and minimized chatter, a GS Shrink Fit Toolholder should far outlast a standard end mill holder Chip load distributed evenly along cutting edge of tool which results in longer tool life Short projections are possible because no mechanical clamping devices are used This results in greater rigidity and resistance to bending Since Shrink Fit toolholders have no moving parts they offer the greatest repeatability of any tool holding system on the market.

Tool Post Holder Number D Tool Post Holder Type Turning Facing Holder Lathe Swing Inch 1018 Overall Length mm 100.

Head Diameter Inch 34 Number of Flutes Multi Included Angle 60 Countersink Material Solid Carbide Countersink FinishCoating Bright Shank Diameter Inch 38 For use on hardened steel up to 60 HRC to countersink or chamfer.

Typhoon end mills with corner radius allow more strength and minimize chipping on the corners in demanding applications.

Drill Bit Size Inch 12 Drill Bit Material High Speed Steel Drill Point Angle Degrees 118 Drill Bit FinishCoating Black Oxide Overall Length Inch 8 Through Coolant No 118Deg point.

.

Drill Bit Size Inch 12 Drill Bit Material High Speed Steel Drill Point Angle Degrees 118 Drill Bit FinishCoating Black Oxide Overall Length Inch 8 Through Coolant No 118Deg point.

Typhoon end mills with corner radius allow more strength and minimize chipping on the corners in demanding applications..