3.5-4 Digital Three Point Internal Micrometer

- Used for zero point setting of outside micrometers - Heat insulating handle to prevent heat expansion due to body temperature - Flat measuring face for up to 11"/275mm size standards, Spherical measuring face for over 12"/300mm size standards.

Drill Bit Size mm 42 Drill Point Angle Degrees 118 Drill Bit Material High Speed Steel Drill Bit FinishCoating Black Oxide Flute Type Spiral Cutting Direction Right Shank Type Straight Coolant Through No 118Deg point.

It can be widely used for boring, milling, drilling and tapping as well as for grinding operation, and is available for all sizes..

Cutter Diameter Inch 6 Cutting Width Inch 58 Tooth Configuration Staggered Material High Speed Steel FinishCoating Uncoated Arbor Hole Diameter Inch 1 Number of Teeth 24.

Drill Bit Size Wire 8 Drill Point Angle Degrees 118 Drill Bit Material Solid Carbide Drill Bit FinishCoating Bright Flute Type Spiral Cutting Direction Right Shank Type Straight Coolant Through No For use on Nonferrous alloys Aluminum Cast Iron High abrasive materials Plastics 20Deg helix angle 118Deg four facet point Bright finish.

Type Mini Die Grinder Collet Size Inch 14 Collet Size mm 6 Handle Type Inline Exhaust Location Rear bull Aluminum alloy housingbr bull Air Pressure 90psibr bull Air Inlet 14 NPTbr bull Air Consumption Loading 13 cfmbr bull Exhaust System Rear.

.060" Radius 4-Flute Reg Length Corner Radius Blue Series Carbide End Mills Four flute construction provides more strength than two or three flute and will also result in excellent surface finishes.5/8" Dia x 5/8" Shank 0.

- Measuring contact points are designed to allow measurements near to the bottom of blind holes - Protection level IP65 - Ratchet Stop - With Setting Rings, S-Wrench, Screwdriver, Instruction Manual, Calibration Certificate.

.060" Radius 4-Flute Reg Length Corner Radius Blue Series Carbide End Mills Four flute construction provides more strength than two or three flute and will also result in excellent surface finishes.5/8" Dia x 5/8" Shank 0.

- Measuring contact points are designed to allow measurements near to the bottom of blind holes - Protection level IP65 - Ratchet Stop - With Setting Rings, S-Wrench, Screwdriver, Instruction Manual, Calibration Certificate.