34 60 Deg, 6Flute Double End Carbide Countersink

Reamer Blank Diameter Wire 52 Overall Length Inch 178 Made from hardened HRC 6365 high speed steel and ground, can be used as punches, gauges, pins or ground for special tools High Speed Steel 00000 0 00003.

Head Diameter mm 25 Number of Flutes 3 Included Angle 90 Countersink Material Cobalt Countersink FinishCoating TiN Coated Shank Diameter mm 10 M35 Cobalt TiN coated Wide flutes provide good chip evacuation Positive cut Constant profile aids regrinding of the tool Selfcentering of the cutting mill three bearing points Virtually eliminates vibration.

Drill Bit Size Inch 532 Shank Taper Designation MT1 Drill Point Angle Degrees 118 Drill Bit Material High Speed Steel Drill Bit FinishCoating Black Oxide Overall Length Inch 8 Through Coolant No.

Drill Bit Size Wire 11 Drill Point Angle Degrees 135 Drill Bit Material Cobalt Drill Bit FinishCoating Gold Finish Flute Type Spiral Flute Cutting Direction Right Hand Shank Type Straight Through Coolant No Taper length drills are designed for general purpose drilling where longer length is required Heavy duty 135Deg split point Sizes over 12 furnished with notched point.

These TiAlN coated ball nose carbide end mills offer excellent performance and tool life in a variety of applications including contour milling.

Jaw Type Square Material Steel Jaw Interface Type 15x60Deg Maximum Compatible Chuck Diameter Inch 12 Minimum Compatible Chuck Diameter Inch 12 Minimum Compatible Chuck Diameter mm 304 Overall Height mm 50 For Autoblok, Howa, Kitagawa, Matsumoto, Shunk.

Head Diameter Inch 34 Number of Flutes 6 Included Angle 60 Countersink Material Solid Carbide Countersink FinishCoating Bright Two cutting ends give you twice the tool life of a single end tool.

Drill Bit Size Wire: #13 Drill Point Angle Degrees: 135 Drill Bit Material: High Speed Steel Drill Bit Finish/Coating: Black Oxide Flute Type: Spiral Flute Cutting Direction: Right Hand Shank Type: Straight Coolant Through: No 135 degree split point Steam oxide coating High Speed Steel.

Head Diameter Inch 34 Number of Flutes 6 Included Angle 60 Countersink Material Solid Carbide Countersink FinishCoating Bright Two cutting ends give you twice the tool life of a single end tool.

Drill Bit Size Wire: #13 Drill Point Angle Degrees: 135 Drill Bit Material: High Speed Steel Drill Bit Finish/Coating: Black Oxide Flute Type: Spiral Flute Cutting Direction: Right Hand Shank Type: Straight Coolant Through: No 135 degree split point Steam oxide coating High Speed Steel.