2-12 X 0.001 Interchangeable Rod Type Inside Micrometer

Jaw Type Square Material Steel Jaw Interface Type Tongue Groove Maximum Compatible Chuck Diameter mm 400 Minimum Compatible Chuck Diameter mm 400 Overall Height mm 80.

Cutting Diameter Decimal Inch 2 Arbor Hole Diameter Decimal Inch 075 Overall Height Decimal Inch 175 Insert Compatibility SE 14M4 Series Max Mill Through Coolant No High quality machining with precise design of insert and cutter Various choice can be offered through variety of combination of insert and cutter Excellent machining performance with light cutter and smooth chip control.

Head Diameter Inch 14 Number of Flutes 6 Included Angle 60 Countersink Material Solid Carbide Countersink FinishCoating Bright Shank Diameter Inch 14.

Collet System Single Angle Collet Series TG100 Shank Type Taper Shank Taper Size NMTB50 Projection Decimal Inch 35.

Material High Speed Steel Blade Diameter Inch 4 Blade Thickness Inch 132 Arbor Hole Diameter Inch 1 Connection Type Arbor Number of Teeth 36 High Speed Steel.

Drill Bit Size Inch: 31/64in Drill Point Angle Degrees: 118 Drill Bit Material: High Speed Steel Drill Bit Finish/Coating: Black Oxide Flute Type: Spiral Cutting Direction: Right Shank Type: Straight Coolant Through: No General purpose 118 degree High Speed Steel.

- Rods marked with its measuring range - Satin chrome finish throughout - All contact points hardened for extra long tool life - With locking clamp - Zero point can be readjusted by rotating the micrometer head sleeve - Carbide tipped measuring faces - With - Micrometer Head, Extension Rods, S-wrench, Instruction manual, Calibration certificate -- Note: Individual rods are matched with micrometer and should not be interchanged with other sets.

.Manufactured of hardened and ground tool steel, these collets can be recommended for their accuracy and fine finish.

- Rods marked with its measuring range - Satin chrome finish throughout - All contact points hardened for extra long tool life - With locking clamp - Zero point can be readjusted by rotating the micrometer head sleeve - Carbide tipped measuring faces - With - Micrometer Head, Extension Rods, S-wrench, Instruction manual, Calibration certificate -- Note: Individual rods are matched with micrometer and should not be interchanged with other sets.

Manufactured of hardened and ground tool steel, these collets can be recommended for their accuracy and fine finish..