Inline Graphite Contacting Conductivity

Name: Inline Graphite Contacting Conductivity - SENSOREX
Brand: SENSOREX
SKU: CBFX-1722613
Price: 754.99 USD
Availability: InStock

About The Inline Graphite Contacting Conductivity

Lab Instruments,Water Quality Testing,Water Testing Meters

Inline Graphite Contacting Conductivity

This chain sling has 4 legs and has a 17' reach.

The thrust point of DIN 6332 grub screws is designed to be used with or without the thrust pad for clamping.

Lab Instruments,Water Quality Testing,Water Testing Meters

Specifications of Inline Graphite Contacting Conductivity
Category
Instock	instock

Last Updated May 25th, 2024 02:42 pm

More Varieties

Rating :- 9.96 /10

Votes :- 29

GN 8170 indexing plungers are intended for use in hygienic areas and meet hygienic requirements on the knob side.

JW Winco GN8170-6-C-FH-H Indexing Plunger Wipers between the knob and the threaded body as well as the sealing ring between the threaded body and the housing keep the mechanics on the knob side sealed. The high surface quality (Ra .

Workholding & Machine Tool Accessories,Spring Plungers

J.W. WINCO

Vertical acting toggle clamps in the U-bar version with two flanged washers (Type A) can accommodate an application specific clamping screw.

GN810-75-C Vertical Toggle Clamp Steel Type E version can either be utilized by welding the clasp which can then accommodate an application specific hold-down fastener component. In the clamped position the operating lever is in its vertical position.

Workholding & Machine Tool Accessories,Fixture Clamps

J.W. WINCO

DIN 6379 double-ended threaded studs are typically used when it is not possible or practical to use T-slot bolts.

DIN6379-M10-125 Double Ended Stud, Steel Subsequent installation of an additional clamp can be achieved even with T-slots of machine tables being covered..

Workholding & Machine Tool Accessories,Hand Knobs and Wheels,Levers & Handles

J.W. WINCO

GN 115 cam latches close via a turning operation limited to 90° (quarter of a turn), which moves the latch arm behind the door frame.

JW Winco GN115-HG-28-SW Cam Latch The beveled edges of the latch arm create a smooth latching of the door..

Door Hardware & Components,Door Latches,Cam Latches

J.W. WINCO

JW Winco GN638-21-1/2X13-94-NV Leveling Feet

.GN 638 ball jointed leveling feet are a low cost solution for clamping operations or for load bearing purposes.

Hardware Supplies,Leveling Feet & Pads,Leveling Mounts

J.W. WINCO

The thrust point of DIN 6332 grub screws is designed to be used with or without the thrust pad for clamping.

DIN6332-M20-90-SKN Grub Screw Unhardened The tip diameter of these grub screws is smaller than the diameter of the threaded stud, allowing them to be screwed into position from the tip side..

Workholding & Machine Tool Accessories,Hand Knobs and Wheels,Handwheels

J.W. WINCO