5/32 Inch Roll Pin Punch

Flex Head Bent.1/2" Drive, 14-3/32" Ultra-Compact, Flex Head Ratchet Drive x 14 In.

•High Leverage –We designed these L-keys to be longer than most other 'jumbo'-sized keys in order to increase leverage when it matters•Tight Tolerances – We measure our hex key tolerances in two ways, from point-to-point and side-to-side, to ensure the highest standards of dimensional accuracy and consistency•6150 Steel – We make our keys with 6150 chromium vanadium steel that's heat-treated to 44-50 HRC to produce tools that are hard, but not brittle•Corrosion-Resistant – We coat all of our keys with a durable manganese phosphate finish that’s resistant to corrosion•Clear Markings – Tekton L-key sizes are marked in two ways, with a high-visibility laser marking and a stamped marking.

. Each socket size meets a minimum of 1.

1/2 Inch Drive x T55 Torx Impact Bit Socket This results in a tool that's higher performing and more durable than traditional 1-piece impact bit sockets. They're designed for use with both friction ring anvils and detent pin anvils..

•Short Arm for Access – The L-key's short arm enables you to stay close to the fastener so that you can work in tighter spaces and with greater control•High Leverage – Our L-keys are longer in overall length compared to competitors, providing increased leverage where it matters•Tight Fit with Fasteners – We precisely manufacture our hex key geometry on the large end of the applicable range, resulting in less slop in fasteners•20-Degree Ball End – Our keys implement a steep ball end angle, which increases your ability to access fasteners while still maintaining sufficient strength•Markings and Finish – Each key is marked with a high-visibility size indicator that can't wear off and finished with a manganese phosphate coating that's highly resistant to corrosion.

.3/8 Inch Drive x 11/32 Inch 12-Point Impact Socket They're designed for use with both friction ring anvils and detent pin anvils.3 times the ANSI/ASME standard for proof torque.

.

.Cold Chisel 5/8 In.

Roll Pin Punch 5/32 In..

Cold Chisel 5/8 In..