2-3 Measuring Range Asimeto Digital Inside Micrometer

Shank Type Taper Shank Taper Size CAT40 Hole Diameter mm 25 Projection mm 100 Nose Diameter mm 44 Through Coolant Yes Unsurpassed Accuracy Concentricity of Less than or equal too00001 3 Micron with tool shrunk in holder Coolant Ports Each holder has 4 coolant ports in the nose to ensure coolant gets right to the tool Max Gripping Torque Tool is gripped 360Deg along the entire length of bore producing very high gripping torque, preventing chatter Increased Production Decrease down time the total time elapsed to remove one cutting tool and insert another is less than 10 seconds Balanced GS follows the strictest balance standards Our holders are prebalanced G25 up to 30,000rpm Extended Holder Life With double tempered tool steel construction, reduced centrifugal forces, minimized bore contamination, and minimized chatter, a GS Shrink Fit Toolholder should far outlast a standard end mill holder Chip load distributed evenly along cutting edge of tool which results in longer tool life Short projections are possible because no mechanical clamping devices are used This results in greater rigidity and resistance to bending Since Shrink Fit toolholders have no moving parts they offer the greatest repeatability of any tool holding system on the market.

100 kg 690mm Articulating Arm Asimeto Magnetic Base Dial gauges can be held by the 3/8" or 8mm diameter stem. Arm has 3 articulating joints that can be locked with the single hand knob or by the lug backing plate.

- Measuring contact points are designed to allow measurements near to the bottom of blind holes - Protection level IP65 - Ratchet Stop - With Setting Rings, S-Wrench, Screwdriver, Instruction Manual, Calibration Certificate.

3/32" 4-Flute Stub Soild Carbide End Mill TiAlN Coated The premium micrograin carbide makes these mills tough enough to machine the very hard metals..

HSSE-V3% Vanadium - Superior performance in stainless steels - Up to 35 HRC.

- Used for zero point setting of outside micrometers - Heat insulating handle to prevent heat expansion due to body temperature - Flat measuring face for up to 11"/275mm size standards, Spherical measuring face for over 12"/300mm size standards.

- Designed for the measurement of intricate internal characteristics - Digital Series has solid carbide pins for measurement contact points - Satin chrome finished - 0.

Even distribution and minimized variation of the tools cutting edges ensure high performance machining and tight tolerances.1250) AA Ultra Precision Collet The result of an improved AA collet in a quality chuck is increased gripping force, improved rigidity, decreased runout, and a renewed confidence in your collet chuck system. Improved system performance and lower cost per piece when used with high quality GS chucks.

- Designed for the measurement of intricate internal characteristics - Digital Series has solid carbide pins for measurement contact points - Satin chrome finished - 0.

Improved system performance and lower cost per piece when used with high quality GS chucks.