2.5mm SA10 Collets

Type ER Collet Series ER25 Hand or Pipe Tap Hand Through Coolant No Tap Size Metric M8 For synchronous, rigid tapping operations using ER collet chuck Collet bore is exact tool diameter with square drive for accuracy and rigidity.

1/4" Diameter x 1/4" Shank 2-Flute Extra Long Length Ball Nose Yellow Series Carbide End Mills These end mills have the capability to mill much thicker material in a single pass, thereby eliminating the interrupted cut that may be present with regular length end mills.

.0-3.

Mill Diameter Inch 12 Number of Flutes 2 Length of Cut Inch 38 Material Solid Carbide Overall Length Inch 3 Shank Diameter Inch 12 FinishCoating Modified AlTiN Single or Double End Single High performance ball nose plus end mills are used in the mold industry and have a full 220 degree arc cutting capability Modified AlTiN coated for improved tool life and increased production output Made from premium submicron grain carbide.

Multi Flute Typhoon end mill design allow them to be run at higher RPM than conventional end mills as well as increase tool life without chipping..

Drill Bit Size Inch 1932 Drill Bit Material High Speed Steel Drill Point Angle Degrees 118 Drill Bit FinishCoating Black Oxide Overall Length Inch 12 Through Coolant No 118Deg point.

5mm SA10 Collets.

Drill Bit Size Inch 1732 Shank Taper Designation MT2 Drill Point Angle Degrees 118 Drill Bit Material High Speed Steel Drill Bit FinishCoating Black Oxide Overall Length Inch 12 Through Coolant No.

5mm SA10 Collets.GS TOOLING 338568 2.

Drill Bit Size Inch 1732 Shank Taper Designation MT2 Drill Point Angle Degrees 118 Drill Bit Material High Speed Steel Drill Bit FinishCoating Black Oxide Overall Length Inch 12 Through Coolant No.