3/8-16 X 5 In Combination Phillips/Slotted Round Machine Screw, Zinc Plated Steel, 50 PK

237 in, Minimum Head Width 0.215 in, System of Measurement Inch, Thread Type Coarse, Package Quantity 100.12 in, Tensile Strength 60,000 psi, Dimensional Standards ASME B18.3, Pack Size Small, Type Standard Machine Screw, Maximum Head Width 0.

3, Flange Diameter Not Applicable.

Fully Threaded Rod, Material Grade/Class Grade B7, Material Steel, Finish Black Oxide, Thread Size 1/4 In.-28, Overall Length 3 ft, Tensile Strength 125,000 psi, System of Measurement Inch, Thread Direction Right Hand, End Type Straight Cut, Dimensional Standards ASME B18.

9, M16-2.Class 10.00 Hex Head Cap Screw, Black Oxide Steel, 100 mm L, 10 PK Thread Length 100 mm, Head Height 10 mm, Head Width 24 mm, Package Quantity 10.

3, Flange Diameter Not Applicable, Flange Thickness Not Applicable.166 in, Head Diameter 0.

-13, Thread Length 1 9/16 in, Anchor Material Steel, Pin Material Steel, Finish Zinc Yellow, Head Type Flat, Head Diameter Not Applicable, Head Height Not Applicable, Nut Width Not Applicable, Washer Outside Diameter Not Applicable, Drill Bit Size 3/4 in, Minimum Installation Depth 2 1/4 in, Maximum Material Thickness 2 in, Ultimate Shear Strength (4,000 psi Concrete) Not Applicable.Hammer Drive Pin Anchor, Anchor Diameter 1/2 in, Overall Length 4 3/4 in, Thread Size 1/2 In.

,PK2 Range -15 Degrees to 400 Degrees F, FDA Approved No, Package Quantity 2 7.

708 in, Drive Size #4, Tensile Strength 60,000 psi, Dimensional Standards ASME B18.

. O-Ring, No Metal Detectable, No X-Ray Detectable, System of Measurement Inch, Cross Section Shape Round, O-Ring Material Viton, Durometer (Hardness) Rating Very Hard, Nominal Inside Dia. 7 1/2 in, Nominal Width 3/32 in, Actual Inside Dia.1 In.

717 in, Minimum Head Width 0.