Solid Carbide Square End Mill, 16 Mm, TiAlN Coated

Medium Duty Gate Handle - SS - 1/4In Rope Connector - Black This is an excellent shortcut product to make a gate using any of the smaller diameter polyropes or polywires up to 1/4In.

4 mm. Steam tempered from dia 2. HSS Jobber Drill, Uncoated, 19.Profile ground: Jobber drill with high pitch accuracy and concentricity as well as precision ground point.

Tweezers- shouldered / sickle shaped pointed- 120 mm- Form 7- Material: AMB electrostatic characteristic: EGB/ESD.

.Material: Made of carbon steel C70- precision stamped and heat-treated- non-reflective phosphate. Electronics snipe-nose pliers with long jaws- overall length: 155mm electrostatic characteristic: EGB/ESD Head width: 13 mm Jaw length: 32 mm 2-component conductive grips- suitable for ESDs.

The special surface structure allows transmission of high torques- even with wet or oily hands.

643801 643809 may be used in combination.With plastic insulation up to 1000 V to DIN EN IEC 60900 / VDE 0682-201. Hexagon socket- 1/2 inch fully insulated- Width across flats: 17mm Square drive: 1/2 in drive output end: 29 mm Length: 59 mm.

Without 45Deg cutting edge chamfer.Eccentric relief ground. Solid Carbide Square End Mill, 16 mm, TiAlN Coated of teeth Z: 4 Flute length Lc: 35 mm Overall length L: 93 mm Shank dia Ds: 16 mm Shank form: HB Feed fz for slot milling in steel . of teeth Z: 4 Helix angle: 30 Deg Direction of infeed: horizontal- oblique and vertical Shank: DIN 6535 HB to h6 No.

Removable sliding clip can be used as a retainer and as a depth gauge.Steel rule with sliding clip- stainless- Length: 150 mm Material: Stainless steel- INOX Metric / Inch conversion table on the back.

Solid Carbide Square End Mill, 16 mm, TiAlN Coated of teeth Z: 4 Flute length Lc: 35 mm Overall length L: 93 mm Shank dia Ds: 16 mm Shank form: HB Feed fz for slot milling in steel .Eccentric relief ground. Without 45Deg cutting edge chamfer. of teeth Z: 4 Helix angle: 30 Deg Direction of infeed: horizontal- oblique and vertical Shank: DIN 6535 HB to h6 No.

. Removable sliding clip can be used as a retainer and as a depth gauge.Steel rule with sliding clip- stainless- Length: 150 mm Material: Stainless steel- INOX Metric / Inch conversion table on the back.