reorder
tools-and-supplies.champsview.com
ALWAYS Be Happy search home
c
Combo Blog
Categories
Play Games New
Bearings,V-belts & Power Transmission Equipment,Power Transmission Belts,V-Belts
CARLISLE BELTS BY TIMKEN

Super II V-Belt Heavy Duty Super II V-Belt, C-R Section, 7/8 In W Top, 132 In L Outside, 9/16 In THK

About The , EPDM

, EPDM

Bearings,V-belts & Power Transmission Equipment,Power Transmission Belts,V-Belts

Super II V-Belt Heavy Duty Super II V-Belt, C-R Section, 7/8 In W Top, 132 In L Outside, 9/16 In THK

Bearings,V-belts & Power Transmission Equipment,Power Transmission Belts,V-Belts

Specifications of Super II V-Belt Heavy Duty Super II V-Belt, C-R Section, 7/8 In W Top, 132 In L Outside, 9/16 In THK

Category
Instockinstock

Last Updated

Super II V-Belt Heavy Duty Super II V-Belt, C-R Section, 7/8 In W Top, 132 In L Outside, 9/16 In THK
More Varieties

Rating :- 9.46 /10
Votes :- 26
Through-coolant: no Tolerance nominal dia : h10 No.

Through-coolant: no Tolerance nominal dia : h10 No.

Without 45Deg cutting edge chamfer. of teeth Z: 4 Helix angle: 30 Deg Direction of infeed: horizontal- oblique and vertical Shank: DIN 6535 HB to h6 No.Eccentric relief ground. Solid Carbide Square End Mill, 16 mm, TiAlN Coated of teeth Z: 4 Flute length Lc: 35 mm Overall length L: 93 mm Shank dia Ds: 16 mm Shank form: HB Feed fz for slot milling in steel .

  • Cutting Tools,End Mills,Carbide End Mills
  • HOLEX
    • Made of Stainless Spring Steel.

    Made of Stainless Spring Steel.

    Steel rule with sliding clip- stainless- Length: 150 mm Material: Stainless steel- INOX Metric / Inch conversion table on the back.

  • Measuring & Marking Tools,Measuring and Layout Tools,Rulers and Straight Edges
  • HOLEX
    • - Longer bolt life.

    - Longer bolt life.

    Note: HT-Drive - the particularly close-fitting profile. With close tolerance jaw width.

  • Hand Tools,Wrenches,Combination Wrenches
  • GARANT
    • Sturdy design suitable for a wide spectrum of materials.

    Sturdy design suitable for a wide spectrum of materials.

    6 mm.1 mm Tapping hole dia : 1.8 mm Shank square : 2.Form C 2-3 turns lead chamfer.

  • Cutting Tools,Taps,Extension Taps
  • HOLEX
    • Sturdy design suitable for a wide spectrum of materials.

    Sturdy design suitable for a wide spectrum of materials.

    8 mm Shank square : 2.6 mm. Improved HSS-E tool material with friction-reduction TiN coating.1 mm Tapping hole dia : 1.

  • Cutting Tools,Taps,Extension Taps
  • HOLEX